Modern Forms
www.modernforms.com
$4;:1 J-D
Headquarters/Eastern Distribution Center
->.;>$->7>5B1J$;>@+-?45:3@;:",
$4;:1 J-D
Western Distribution Center
>/45.-80B1J#:@->5;
$4;:1 J-D
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
JUNE 2019
PREPARATION
1. Shut off the power at the circuit breaker and remove
existing fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE
(
FIG.1
)
3.
Drill holes in the ceiling aligned with the key
hole location in the mounting plate.
4.
Insert the mounting anchors (A) into holes.
5.
Secure the mounting plate to the junction box using
junction box screws (D).
NOTE:
The side of the mounting plate
marked “GND”
must face out.
6.
Fasten the wood screws (B) into the mounting
anchors (A) (installed in the ceiling) and tighten.
7.
Slide the glass (RPL-GLA-58756) into the fixture.
8.
On each end of fixture, angle-in the end caps
and press in to secure.
9.
Adjust the fixture wire length by pressing the
cable-
grippers on canopy and pulling the wire.
Make sure both wires are the same length.
10.
Re-set the strain relief near the wiring holes.
CONNECTING THE WIRES
(
FIG.2
)
11.
Connect the transformer input wires with supply wires as shown
(Fig. 2). Make
sure that all wire connectors are secure.
12.
Cut the fixture wires and leav
e
at least 6”. Connect with the transformer output wires
(
red
)
.
N
OTE
:
The fixture wires have two braided layers. Strip the two layers carefully.
If your outlet box has a ground wire, connect it to the fixture’s ground wire. Otherwise, connect the fixture’s ground wire directly to
the mounting plate (D1) using the green screw provided. Tuck wires carefully inside the junction box.
13.
Place the canopy over the mounting plate, secure with mounting screws (E).
14.
Check if fixture is level and adjust cables if necessary.
*Continue instruction
s
for changing to decorative wood canopy
A
C
B
D
E
FIG.1
Junction Box
Ground Wire
Ground Wire Screw
Input
Transformer x2
(Output)
Cable-gripper
Mounting Anchors
Supply Wire
Wire Connector
Mounting Plate
Wood Screws
Junction Box Screws
Strain Relief
Mounting Screws
Canopy
End
Caps
Glass
(RPL-GLA-58756)
Light fixture
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
INSTALLATION INSTRUCTION
S
Drift
PD-58738 / PD-58756 / PD-58784
/
PD-58738F / PD-58756F / PD-58784F
