8
OPERATION
MAINTENANCE
OPERATION
On the lower right corner of the right side of the fire unit, near the power cord, is the main power
switch. Switch this on to begin using the fireplace. Directly below the flame, on the right hand side
are 3 control switches.
To begin operation touch the Power button. The flame image and fire feature will be on at full bright-
ness and the heater will be off.
All buttons on the remote function in the same manner as the buttons on
the main unit.
To begin operation touch the Power button. The flame image and fire
feature will be on at full brightness and the heater will be off.
Pressing the Dimmer button will cycle the brightness of the flame image
and fire feature. There are 5 levels of dimming.
Pressing the Heat button will start the heater and fan at low speed. The
low heat indicator will light. Pressing the Heat button again will turn the
heater on high. The high heat indicator will be lit. Pressing the Heat
button once more will turn off the heater. The indicator lights will turn off.
Pressing the Heat button will start the
heater and fan at low speed. The low
heat indicator will light. Pressing the
Heat button again will turn the heater
on high. The high heat indicator will be
lit. Pressing the Heat button once more
will turn off the heater. The indicator
lights will turn off.
Low Heat
High Heat
Pressing the Dimmer button will cycle the brightness of the flame image and fire feature. There are
5 levels of dimming.
5
INSTALLATION
UNPACKING AND TESTING
This heater is for use on 120 volts. The cord
has a plug as shown at A. An adapter as
shown at C is available for connecting three-
blade grounding-type plugs to two-slot recep-
tacles. The green grounding lug extending
from the adapter must be connected to a per-
manent ground such as a properly grounded
outlet box. The adapter should not be used if
a three-slot grounded receptacle is available.
CAUTION: The unit's power supply cord
must be connected to a properly
grounded and protected 120-volt outlet.
Always use ground fault protection
where required by the electrical code.
Never use an extension cord with this
product.
WARNING: Do not operate the unit if it is
damaged or has malfunctioned. If you
suspect the unit is damaged, return the
unit to an authorized service facility for
examination, electrical or mechanical ad-
justment or repair.
LOCATING FIREPLACE
CAUTION: Do not locate in a moist room such as a bathroom or laundry room.
CAUTION: Wear gloves and safety glasses for protection during installation and mainte-
nance.
This fire is designed to fit into existing fireplaces as an insert to replace a wood or gas burning fire.
This fire can also be used in cabinets or recessed wall openings.
A
C
Grounding Pin
Metal Screw
