Modena WF 652, Руководство пользователя

Страница: 26 / 39

English 25
3. Level adjusment of unit
-
The machine must stand perfectly
level on all four feet to ensure
safe
and proper operation.
Incorrect installation may increase
electricity and water consumption
and may cause the machine to
move about.
-
Washing machine is equipped
with legs which can be adjusted
height. If the uneven floor surface,
turn clockwise of locknut using
the wrench. Then turn the locknut along with legs units to loosen. Adjust the height of each leg
until flat and sturdy.
-
Use a spirit level to check the machine is standing level. Hold adjust feet securely with a pipe
wrench. Turn locknut again using the spanner until it sits firmly up against the housing.
4. Drain hose connection
a. Direct into a sink
-
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed
in the drain hose to prevent waste from the sink entering the washing machine. If required, the
drain hose can be extended to a length of 4 m.
-
If required, the drain hose can be extended to a length of 4 m.
b. Connected securely to a standpipe.
-
Firstly form a hook in the end of the drain hose using the “U” piece” supplied. Place the drain
hose into your standpipe, which should have an internal diameter of approximately 38mm thus
ensuring there is an air break between the drain hose and standpipe. When discharging into a
standpipe ensure that the top of the standpipe is no more than 90cm and no less than 60cm
above floor level.