Modena ES 10D, Руководство пользователя

Страница: 29 / 44

English 26
3.1 Installation Instruction
- This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot bear
the load equal to two times of the total weight of the heater filled fully with water, it is then
necessary to install a special support. In case of hollow bricks wall, ensure to fill it with cement
concrete completely.
- After selecting a proper location, install the mounting bracket to a solid wall.
- Methods of installation: Hole depth of approximately 45mm.Use the anchors and fasteners
provided along with the product for securing the bracket (Diagram 7) firmly in the wall.
- Align the slots on the back of the water heater with the projections on the bracket and mount the
water heater on the bracket. Thereafter slide the water heater gently towards the bottom side on
lock the water heater.
- Install the supply socket in the wall. The supply socket be 220V. It is recommended to placed the
socket on the right above the heater. The height of the socket to the ground shall not be less than
1.8m (see Diagram 8). If there is fault on power cable, it should be replaced by MODENA,
agencies or qualified person who is able to do this so as to ensure the safety.
- If the bathroom is too small, the heater can be installed at another place. However, in order to
reduce the pipeline heat losses, the installation position of the heater shall be closed to the
location shall be as near as possible to the heater.
3.2 Pipelines Connection
- The dimension of each pipe part is G1/2 (
”BSP ½”) ; The massive pressure of inlet should use Pa
(Bar) as the unit; The minimum pressure of inlet should use Pa (Bar) as the unit.
- Connection of pressure relief valve with the heater on the inlet of the water heater.
- In order to avoid leakage when connecting the pipelines, the rubber seal gaskets provided with
the heater must be added at the end of the threads to ensure leak proof joints (see Diagram 9).
Part 3:
Installation