Modena CT Series, Руководство пользователя

Страница: 19 / 26

English 17
Precautions & Recommendations
Transportation and Storage:
During transportation, please handle the appliance carefully and no upside down to prevent the
damage of the enclosure and inner parts. The packaged device should be stored in a well-ventilated
warehouse of no corrosive gas. Should any temporally storage needed, please take measurement
against raining.
Notice for Installment:
1. All the installation of this device should be done by professional and qualified personnel.
2. The connection shall comply with the regulations of gas safety, installation and use.
3. Care should be taken to its weight when installation due to its relative heavy weight. It is
advisable to mount it on floor.
4. Make sure that the sides are away from non-combustible material (eg. Brick walls or windows) no
less than 10 cm, and the rear at least 20 cm. Do not mount it on inflammable floor or material.
5. The appliance should be located in a well ventilated place with air exhaust facilities to ensure that
the steam and burned gases can be discharged during operation.
6. The mounted appliance shall be secured, lying horizontally, with no tilting or shaking when using.
7. The user shall apply for the permission of the gas supplier for using such gas type in prior to the
installation of the appliance. Only install it after verification that the supplied gas is same as the
gas to be used in the future.
Gas Connection:
1. Use neither gases which are not applicable for this device nor any high or middle pressure
regulation valves. (it is only applicable for low pressure regulation valve).
2. Before installing the device, there shall mount a quick-acting gas cut off valve, which shall also
be at the upstream near the device and ready accessible.
3. Ensure that the connected gas type is the same as the rated gas type of the device, if not, do not
use it.
4. The conduit which is connected to the device shall be connected by metal pipe.
5. If the conduit pressure is higher or lower than the required pressure of the device of 10%, there
shall install a regulator to ensure the rated pressure.
6. After connecting, test the tightness of the joint with a solution of water and soap or detecting
instrument. “Do not check it with open flame!!!”
Special note
1. The installation, initial start up and maintenance of this device shall be done by professional
personnel or installation personnel have been approved by manufacturer.
2.
Remove the package, make sure that the device is intact. If there’s any doubt, please do not use
it and consult to professional person. Never place the packing material at a place where children
can touch it to avoid danger. (the material is plastic bags, nails and so on).
3. When use this device for the first time, the ignition time may be a little longer due to the air in the
newly installed conduit. If it doesn’t ignite at the first time, turn off the ignition switch and re-ignite
it after 3 minutes’ interval to avoid deflagration.
4. Use neither gases which are not applicable for this device nor any high or middle pressure
regulation valves. The supplied gas must be in accordance with the device applicable gas, if not,
do not use it.
5. When stop using or when the operator is not attended, the device must be turned off to prevent
against danger.
6. This is a commercial machine which is not applicable for home use. All the operation shall be
done by trained & professional personnel.
7. It is only intended for commercial use, otherwise it would be dangerous.
8. Do not dismantle or modify the device, serious accidents may happen when dismantling or
modifying.
9. Do not pat the device or place heavy objects onto the device. Abnormal operation may cause
damage and danger.
10. Do not store any substances at the smoke vent of the gas heater to prevent obstruction of the
discharge of fumes that can cause hazardous to personal health.
Part 2: Installation