Modena BO 7838, Руководство пользователя

Страница: 7 / 56

7
•
Have an authorized electrician set grounding equipment. Our company shall not
be responsible for the damages that shall be incurred due to using the product
without grounding according to local regulations.
•
The circuit breaker switches of the oven shall be placed so that end user can
reach them when the oven is installed.
•
The power supply cord (the cord with plug) shall not contact the hot parts of
the appliance.
•
If the power supply cord (the cord with plug) is damaged, this cord shall be
replaced by the manufacturer or its service agent or equally qualified personnel
to prevent a hazardous situation.
•
Never wash the appliance by spraying or pouring water on it. There is a risk of
electrocution.
•
WARNING: To avoid electric shock, ensure that the device circuit is open before
changing the lamp.
•
WARNING: Cut off all supply circuit connections before accessing the terminals.
•
Do not use cut or damaged cords or extension cords other than the original cord.
•
Make sure that there is no liquid or humidity in the outlet where the product
plug is installed.
•
The rear surface of the oven also heats up when the oven is operated. Electrical
connections shall not touch the rear surface, otherwise the connections may be
damaged.
•
Do not tighten the connecting cables to the oven door and do not run them over
hot surfaces. If the cord melts, this may cause the oven to short circuit and even
a fire.
•
Unplug the unit during installation, maintenance, cleaning and repair.
•
If the power supply cable is damaged, it must be replaced by its manufacturer
or authorized technical service or any other personnel qualified at the same
level, in order to avoid any dangerous situation.
•
Make sure the plug is inserted firmly into wall socket to avoid sparks.
•
Do not use steam cleaners for cleaning the appliance, otherwise electric shock
may occur.
•
An omni polar switch capable to disconnect power supply is required for
installation. Disconnection from power supply shall be provided with a switch
or an integrated fuse installed on fixed power supply according to building code.
•
Appliance is equipped with a type ‘’Y’’ cord cable.
•
Fixed connections shall be connected to a power supply enabling omni polar
disconnection. For appliances with over voltage category below III,
disconnection device shall be connected to fixed power supply according to
wiring code.