12
The appliance must be installed and connected in accordance with
current regulations. After unpacking the appliance, ensure there is no
visible damage. If it has been damaged during transit, DO NOT USE,
contact where you buy immediately.
Selection of Installation Equipment
•
Cut out the work surface according to the sizes shown in the
drawing.
•
For the purpose of installation and use, a minimum of 5 cm space
shall be preserved around the hole.
•
Be sure the thickness of the work surface is at least 30mm.
Please select heat-resistant work surface material to avoid larger
deformation caused by the heat radiation from the hotplate. As
shown below (measure by unit: mm):
INSTALLATION