© MOBOTIX AG www.mobotix.com Vertraulich / Confidental * MERGEFORMAT
2107_QI_S74 Long Cable Extender_en.docx • 01.09.21 • Seite/Page 3/ 6
MOBOTIX Long Cable Extender
3) Electrical Link:
Remove the cover of both Long Cable Extender boxes. Make
sure to connect the same wires to each side of the connectors
on both Long Cable Extender boxes. Apply the cable shield to
the board by using the cable tie.
Use the white rubber plug and cut off as many steps as
necessary to properly fit to the used cable. Make sure the rubber plug is properly sealing the opening of the boxes.
Please Note: The tightening torque of the Long Cable Extender cover should not exceed 25Ncm.
Connection Overview:
Camera Setup:
Go to the Admin Menu - Hardware Configuration - Sensor Module Configuration and set the Cable Length to "Long
(>2 meters)" and reboot the camera.
