MOBILTEX® DATA LTD.
TITLE:
Installation and Operating Instructions
Calgary, Alberta
DOCUMENT NO.:
SPI1-MAN-001
SHEET:
16 of 57
REV:
1.14
Figure 13 SPI1 Programming Cable
Figure 14 shows the GPS antenna supplied with the SPI1 Portable Interrupter. The antenna has a 3 meter cable
attached that is terminated in a TNC connector. The TNC connector must be threaded onto the GPS antenna port on
the SPI1 Portable Interrupter during operation. The antenna top face must be oriented as shown.
Figure 14 SPI1 Portable Interrupter GPS Antenna
Figure 15 shows the GPS antenna used with the SPI1 Stationary Interrupter. The antenna has a 3 meter cable attached
that is terminated with an SMA connection. The SMA connector must be threaded on the GPS antenna port on the
rear of the SPI1 Stationary Interrupter.
