STEP 8
When bathing is finished press the UP
button and this will raise and return the
user back to the original bath height, so
that the bather can again hold on to the
grabrail and place their feet over the bath
edge and onto the floor
STEP 9
With the belt slackened, free the end
secured to the floor bracket. By pressing
the up button once more the seating belt
will retract back into the cabinet, ready for
future use. Leave about 75 mm (3”) of
the belt outside the unit.
INDICATOR LIGHTS
When the buttons are pressed, the unit
will ‘come to life’ and the green indicator
light will illuminate together with the
temperature module. If the unit is not in
use for more than 30 seconds it will ‘go to
sleep’. This conserves the battery. When
the button is pressed the unit will again
illuminate.
A red light will appear on the front of the
unit to indicate that the battery is low.
However, after this light appears there is
still enough power in the battery to lift you
out of the bath. You should, however,
charge the battery IMMEDIATELY.
MAINTENANCE
With attention to regular recharging, the
battery should provide about two years of
reliable service. To replace the battery at
the end of its life, simply release the three
screws which are at the opposite end to
the pull out handle. Remove the TWO
batteries positioned in line within, and
replace with two NP1.2-12 volt sealed
lead acid batteries, and reassemble.
These are available from most battery
stockists throughout the United Kingdom
and the continent at a modest cost.
It is important to mention that batteries at
the end of their working life must be
disposed of environmentally safely – e.g.
they must NOT be disposed of on an open
fire or by any other hazardous means.
Whilst stainless steel is used to totally
eliminate rust on the interior of the cabinet it
is important to understand that as the unit
must have entry points for the battery and
the hand control unit it is NOT waterproof.
WATER CAN GAIN ACCESS.
When showering, care must be taken to
avoid soaking the unit with an excess of
water which could damage the interior
electronics. There is a purpose made
shower cover protection cap which your
Distributor can supply.
6
Instructions updated:BATHLIFT RELAXA 5/8/10 15:52 Page 6
