Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
Mounting and assembly instructions
The rubber ramp mounting kit consists of two mounting brackets that are installed in the doorstep. It is then possible
to mount rubber ramps without gluing the ramp to the substrate (item no. 306910).
Mounting kit (306910)
Mounting bracket mounted into the doorstep
Doubvle
adhesive tape
(12)
Degreaser for removal
of glue
(306905)
Cutting of rubber ramps
The rubber ramps are easily adjusted in width with a sharp hobby knife or saw blade from Mobilex (art. no. 306904).
For higher ramps, it is necessary to cut several times in the same groove. After each cut, break the ramp backwards to
facilitate the next cut.
Low ramp cutting
High ramp cutting
Ramp ready for use
Possibility to combine the ramps with modular construction
Measurements on the outside, inside and possibly the height of a rubber ramp. Choose suitable ramps.
Can also be built on top of each other.
Combined ramps for desired height
Adaptation of ramps to doorsteps of different heights
Accessories
The following accessories are available for the rubber ramps:
Mounting set for rubber ramp zinc plated, 28-60 mm height (306910)
Jigsaw blade for rubber ramp (306904)
Double adhesive tape, width 20 mm, length 50 meter (306911)
Double adhesive tape, width 35 mm, length 50 meter (306912)
Degreaser for removal of glue 1/2 L (306905)
Transport recommendations
The ramps are removable if not glued and can therefore be easily moved to a new location if necessary
Rev. 10.05.22
12 - 24
UM-306040-306601-MULTI10052022.odt