Your Base Station has voice announcements. Select announcements are listed below:
The Cellular Base
Station is powered on
“System eady”
Base Station ON/OFF switch has been turned on be sure
to connect to electric outlet or it will run on battery backup.
Both red Emergency
and blue Reset Buttons
“Power not detected ” or
“Power detected ”(when
electricity is reconnected)
Check that the Base Station is correctly plugged
into an electrical outlet.
The battery needs
charging
“Low attery”
Check that the Base Station is correctly plugged into an
electrical outlet or it will run on battery backup.
The Emergency call is
initiated
“Call in progress ”
Alarm is being sent to the Emergency Response Center.
Call connected
“Please stand by
for operator ”
Respond to the emergency operator’s call over
the device speaker.
Cellular Base Station
receives a Fall Signal
“Fall etected Press and
hold utton to ancel”
cancel the alarm. During this time, you may press and hold the
Fall Alarm is canceled
“Alarm anceled ”
Alarm has been canceled.
There may be situations where the voice prompts don’t complete the entire phrase
event occurs. In this instance, the latter voice prompt event will cut in
and the current voice prompt may be terminated prematurely.
All devices frequency transmission = 433 MHz
SRDR-00023 Rev. 2
SRDR-00023 Rev. 2
The Mobile Device 5.0 provides voice announcements. Select
announcements are listed below:
The
Mobile Device is powered on
mergency call is initiated
“Call in
“System Ready”
rogress ”
The battery is low
“Your battery is low lease connect
to a power source.”
Mobile Device 5.0
