MA 850A1 Connections, LEDs and Ports
MA 850A1A1 Installation and Configuration Guide
8
Front Panel LEDs
The front panel contains two LEDs, described in the following table.
Table
1-2. Front Panel LEDs
Front Panel LEDs
Description
Run
Internal operation and channel operation status:
Green blinking – unit OK
Off – fault detected in unit
Red blinking – failure of one of the channels
PWR
(Unlabeled LED adjacent to the power connection).
Green – Power OK.
1.6.2
Rear Panel Port Connections and LEDs
The rear panel contains the 802.11a/b/g AP connections, Ethernet connection for remote
management and antenna sensing connector.
Figure
1-11. MobileAccess 850 Rear View
Rear Panel Ports
The following table describes the rear panel ports.
Table
1-3. Rear Panel Ports
Rear Panel Ports
Description
802.11b/g APs
Connection to four 802.11
b/g
APs.
802.11a APs
Connection to four 802.11
a
APs.
Connection to
control
Relevant only when MA 1000 RHU services are integrated with
MA 850A1 services. Connects to the RHU rear panel Control
connector. Routes the antenna sensing (indication of whether
antenna is present) to the RHU for monitoring via the
management application. (RHU Version 3.1 and higher).
Ethernet port
Connection to network for configuration and management
through a WEB browser.
The default IP Address is on the label
near the port.
802.11b/g APs
connections
Ethernet Port
802.11a APs
connections
Antenna sensing
connector
802.11b/g AP Status LEDs
