Mobile ECO MINEY, Инструкция по эксплуатации и перечень запасных частей

Страница: 4 / 13

3.4 If the forks do not elevate while pumping in the RAISE position, turn the nut (G104) or screw
(318) counter-clockwise until the forks elevate while pumping in the RAISE position. Then
check the LOWER and DRIVE position according to item 3.1, 3.2 and item 3.3.
4. MAINTENANCE
The pallet truck is largely maintenance-free.
4.1 OIL
Please check the oil level every six months. The oil can be hydraulic oil: ISO VG32, its viscosity
should be 30cSt at 40
0
C, total volume is about 0.4lt.
4.2 TO BANISH THE AIR
The air may come into the hydraulic oil because of transportation or pump in upset position. It can
cause that the forks do not elevate while pumping in the RAISE position. The air can been
removed in the following way: let the control handle (G117) on the LOWER position, then move
the draw-bar up and down for several times.
4.3 DAILY CHECK AND MAINTENANCE
Daily check of the pallet truck can limit wear as much as possible. Special attention should be
paid to the wheels, the axles, as thread, rags, etc. It may block the wheels. The forks should be
unloaded and lowered in the lowest position when the job is over.
4.4 LUBRICATION
All bearings and shafts are provided with long-life grease at the factory. You only need provide
with long-life grease at monthly intervals or after each time the truck is cleaned thoroughly to the
lubrication points.
5 GUIDE TO SAFETY OPERATION
5.1 Operator should read all warning signs and instructions here and on the pallet truck before
using this truck.
5.2 Do not use on sloping ground.
5.3 Do not operate a pallet truck unless you are familiar with it and have been trained or
authorized to do so.
5.4 Do not operate a pallet truck unless you have checked its condition. Give special attention to
the wheels or rollers, the draw-bar unit, the fork unit, the lever plate, etc.
5.5 To pull the truck, always move the control handle into the drive position. This makes the
draw-bar easier to move and depressurizes the pump section of the hydraulics. This
preserves the hydraulic seals and the valve components. A long service life can be expected.
5.6 Do not take up any people on the pallet truck.
5.7 The operator had better take on gloves for labor protecting.
5.8 When the goods have been transported, all people should be away from the forks for 600mm.
5.9 Do not load goods like fig. 5/B and load over maximum capacity.
5.10 At others unusual conditions or places, the operator should take care in operating the pallet
truck.