Mobile One HMP-1 Series, Инструкции и руководство пользователя

Страница: 8 / 12

8
PARTS REPLACEMENT
(See items 1 – 4 pictured in Figure 6.0)
The LEATHER HEAD BAND COVER (item 1) is simply wrapped around the Head
Band with the edges overlapping so that the Velcro seam can be evenly pressed
together. To remove the cover, pull the top overlap away from the bottom at the
Velcro seam.
The EAR CUSHIONS (item 2) are removed by placing one or two fingers inside the
Ear Cup and under the Ear Cushion’s rigid plastic plate. Hold the Ear Cup firmly
with the other hand and pull the Ear Cushion plate until it pops out of the Cup. The
new Cushions just clip back into place under the lip around the circumference of the
ear Cup opening. Ensure the Ear Cushion plate has seated and clipped-in properly
before use.
The INNER FOAM ASSEMBLY (item 3) also supports the Earphone and care
should be taken not to damage the wiring. With the Ear Cushions removed,
carefully take out the foam wafer and pull apart the two bottom layers where the
wires enter. Carefully remove the Earphone. Place the Earphone into the new foam,
remove paper cover and press both layers together. Install foam back in cup and
replace Ear Cushion.
The WIND SOCK (item 4) is the black foam cover for the Microphone at the end of
the Mic. Boom. To remove, simply pull the Wind Sock off the end of the Microphone
and gently stretch and pull the replacement Wind Sock over the Microphone again.