Like BlastmasterXL on FACEBOOK™
www.mobilefidelityinc.com
(208) 720-6315 OI V5
2
1.Initial Assembly Required- Getting Started
Your Blastmaster XL will not perform properly unless theese
Initial Assembly Procedures are followed.
Upon your receiving of the Blastmaster XL you will need to acquire the
following battery or batteries and complete the following assembly:
(Tools needed: wrenches 9/16” &1/2, and 7/16”, crescent wrench/
pliers)
a.
Battery install-
You will need to get and
install (1 or 2) deep cycle
marine batteries, lead acid
sealed AGM size 34. Be
sure to get from the battery
supplier the complimentary
riser support for series 24
battery tray compatibility
(FIGURE 1). Batteries are
not included- installation is
required. We recommend
starting with one battery
and installing it in the rear/
left end battery
compartment (viewed from
the back of unit). This
weight placement will make
for easier loading and
unloading of your Blastmaster XL into transport
vehicles. Have a professional/knowledgeable person install
this electrical component as a shock risk/ hazard exists. Be
sure to cover battery terminals with provided covers.
Secure battery with
provided bracing system.
ONLY remove the front
bottom nut and rod. Swing
top mounting bar aside,
place your battery in the
tray, and then swing back
upper cross brace(FIGURE
2) and secure. Tighten
back nut (top) and front nut
(bottom) (FIGURE 3)
locations equally for safe
secure attachment of your
battery. Cover battery
terminals with protective
covers after thorough
tightening of terminal
clamps is complete.
(FIGURE 4)
Install provided wagon
carriage handle with
provided through bolt
(temporarily installed in
handle during shipping).
Tighten so that metal side
flanges touch plastic
spacers for a snug,
(FIGURE 5) non-vibrating,
easy/smooth operation of handle. Additional future tightening
may be required after repeated use.
b.
Head Unit Initial Set up
The upper round toggle
switch turns on power to
the head unit . The
“Source” button on the
head-unit turns the head
unit on/off and also does
music input selection. The
large round button/dial will
be used for selecting the
following settings for your
initial setup. You will start
with SET UP- YES.
(FIGURE 6).
On the head-unit pushing
and rotating the large
round dial, cycle to the
INITIAL settings section
(FIGURE 7). Rotate dial to set to SP-P/O MODE
(FIGURE8). Then set to
REAR/REAR (FIGURE9) -
this sets the output sound
signal to run to the
external amplifiers.
Proceed using the round
dial and return button to
get to AUDIO setting.
Through the AUDIO
settings (FIGURE 10) get
to the EQ SETTING section (FIGURE 11), set it to
NATURAL(FIGURE 12). This is a good initial setting for the
head unit internal
equalizer.
From this point forward we
suggested that you use
the separate external
equalizer for finer
adjustments- see EQ
section below. You should
read the head-unit
provided owners manual
as you will likely desire to
set up your own custom
internal EQ settings for
optimal sound
performance.
Continue using the round
button and the return
button to go to
LOUDNESS and select
LOW (FIGURE 13). Lastly,
cycle with the buttons to
the S.RTRV screen and
select 2 (FIGURE 14).
FIGURE 1
FIGURE 2
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 3
FIGURE 4
FIGURE 5
