Object / Food Temperature
•
Ensure the unit is in ‘
Object
mode’.
In the upper right-hand corner, there will be an icon of a bottle.
If you do not see the bottle icon in the upper right hand corner p
ress and release the ‘MODE’ button
to
switch modes until the correct icon displays on screen.
•
For optimal results point the unit towards the ‘
object
’ holding the probe 0.4
- 2 inches away from the
object.
•
Ensure you point the unit first, and then press and release the ‘ON/Scan’
button. Scanning before
correctly positioning the thermometer will result in inaccurate readings.
•
Allow 1-
2 seconds after pressing the ‘ON/Scan’
button for temperature to display (if the sound is on
thermometer will ‘beep’ once)
Room Temperature
•
When the thermometer is turned on, it will display the ambient room temperature.
In the upper
middle section, there will be an icon of a house.
Troubleshooting
•
Resetting the Thermometer
To reset your thermometer, take out the batteries for 1 hour while storing the unit in a warm place with
sunlight. Make sure the sensor of the thermometer isn
’t in direct contact with the sunlight, only the body of
the thermometer. After the 1 hour, insert the batteries and turn on the device.
•
ErrE
If you receive and
‘E
rrE
’ message on the screen
, place the thermometer in sunlight or a warm place and let
sit for 30 minutes.
•
HI
‘
HI
’
is displayed for all results above 109.2 °F (42.9°C). Please ensure that you are in correct reading method.
•
LO
‘
LO
’
is displayed for result below 89.6 °F (32.0°C). Please ensure that you are in correct reading method.
Care and Maintenance
•
It is recommended that the thermometer is stored in a dry place free from dust.
•
Do not expose sensor to direct sunlight or air conditioning/fan that will tamper with the
thermometer sensor.
•
Please do NOT expose thermometer to any humidity or water (non-waterproof).
•
To clean the unit, please use an alcohol swab or wipe. Do not use water directly. Ensure all residual
alcohol has evaporated before use.
