Mobeye WaterGuard CM2300, Руководство пользователя портала

Страница: 25 / 32

24
In order to switch on (arm) the Mobeye WaterGuard:
- Press the on/ off button at the upper side for 1 second. The green LED blinks
once every 3 seconds (battery-powered) or
stays ‘on’ continuously (in case of an
external power supply).
If powered externally (GSM is open), switching can be done via SMS commands:
SMS command to switch on: CODE ARM
SMS command to switch off: CODE DISARM
example: 1111 ARM
The status can be requested via SMS command CODE STATUS? (1111 CODE?).
7.3 CONFIRMATION OF THE ALARM MESSAGE
When the system is triggered it will send alarm notifications. First an SMS text
message is sent to all programmed alarm numbers, followed by a phone call. When
you pick up the phone, you will hear beeps. It is possible to acknowledge the phone
call by answering the phone and pressing any key. The other alarm numbers will not
be called afterwards. This works for most telephones.
By switching off the SMS function the system will only call. This prevents the other
numbers being notified by SMS.
7.4 SYSTEM RESET
To reset the Mobeye WaterGuard to its factory settings:
1. Remove the batteries (and external power supply).
2. Press the outside button while reinserting the batteries. Keep it pressed for
(about) another 5 seconds.
3. Release the button immediately after the LED starts to flash.
4. If relevant, connect the external power supply.
After a successful reset, the status LED on the keypad will blink green to indicate
that the module is not configured. The security code is back to factory settings as
well.