8
When using the Mobeye SIM card:
The Mobeye SIM card is PIN code secured and will only work in a Mobeye
device. Please do not place it in another device.
When using your own SIM card:
An
own SIM card has a “micro” format, is suitable for the 2G network and can
make calls and send text messages. The PIN code is "0000", or the SIM card
is PIN code free.
(A PIN code can be changed or removed by putting the SIM card in to any mobile phone
and entering the 'security' menu.)
Note: make sure that the power supply is removed when inserting or
changing the SIM card. The settings are stored in the device memory.
3.2
CONNECT THE WATER SENSOR
Plug the water sensor into the socket and press
it firmly.
3.3
INSERT THE BATTERIES
Insert the two batteries (CR123) in the module. Use the +/- indication for the
correct placement. If you replace the batteries the settings will not be
deleted, since they are stored in the device memory.
3.4
CONNECT AN EXTERNAL POWER SUPPLY (OPTIONALLY)
Although the WaterGuard is designed to run on batteries, it is possible to
use an external power supply. In this mode the module is always connected
with the mobile network and therefore always in program mode. When the
power fails, the batteries take over and a power
failure alarm message is sent. The module
continues operating albeit in the low power
mode. This means the communication module
switches off and only establishes network
connection when it needs to send an alarm
notification, test message or low battery alert.
Connect the power adapter (or any other regulated 12V DC power supply) to
the power input of the connector (press on the green pins to connect the
wires).
