Mobatime 203433, Инструкция по установке и эксплуатации, Страница: 6 / 24

© MOBATIME 6 / 24 800695.14
3. Mounting guidelines
3.1 Mounting of movement series 190(t) (S)
The dial must be sufficiently stable. The fixing hole must have a
diameter of 12.3 mm. The movement must be fixed in vertical position.
Fig. 3 shows the positions of the mounting parts.
The disc nut (2*) M12 x 1 has to be tightened carefully with a special
wrench tool (Art. No.: 201998) and a torque wrench with a torque of (4.5
+/- 0.2) Nm.
Caution:
The ring nut (5), the compensation ring (6) and the spring washer (7)
must not be removed.
After tightening the disc nut (2*), the movement must not be wrenched!
3.2 Mounting of hands and starting-up
3.2.1 Mounting of hands
The shafts of the hour, minute and second hands are positioned ex-work on
the reference position (12 o’clock). The hands must be carefully fixed and
tightened on the shafts. Enough space must be provided between the hands.
See Fig. 4.
The position 12 o’clock must be checked for each movement after mounting
(see chapter 3.2.2).
3.2.2 Starting-up and check of the hand positions

Set DIP switch 1.1 to ON position (12:00 position, refer to chapter 4.2).

Either install a 24 VDC power supply and/or connect to PoE (Power over Ethernet). The clock runs
to the 12:00 position.
 Are the hands exactly positioned at 12:00 position?

If any hand position is wrong the hands must be adjusted again (axis must not be moved).
 Check the 12:00 position again (initialize procedure by interrupting the power supply or by
disconnecting PoE respectively).

If the hand position is OK continue with chapter 4 for further configuration.
Fig. 3
1 Movement
2 Disc nut
3 Rubber washer
4 Dial
5 Ring nut
6 Compensation ring
7 Spring washer
1
2
3
4
2*
190t
5
6
12
.3
7
Fig. 4
x
x
x