Mobatime 121059, Монтаж и инструкция по эксплуатации

Страница: 59 / 124

© MOBATIME 59 / 124 801203.10
6. Gateway in IPv6 format
7. IPv6 DNS server
6.5.25 Link aggregation LAG
This device supports aggregation of two physical Ethernet ports to one logical high-
bandwidth data path (LAG) compatible to IEEE 802.3ad. LAG can be used for fault
tolerance (redundancy) and/or load balancing.
DTS 4210.timecenter Moser-Baer AG
====================================
NETWORK LINK AGGREGATION LAN 2
1 Mode (0=off, 1=on) 0
2 LAG Mode 4
3 Rate (0=slow, 1=fast) 1
4 MII monitor 100ms
98 Return and save
99 Return and discard changes
Enter desired menu number>
Path: 2 Configuration

5 Network

2 LAN 2

11 Link aggregation
Notice: LAG is only possible for LAN 2+3, LAN 6+7, LAN 10+11 and LAN 14+15
The network configuration has to be done always on the first interface
(e.g. LAN2 for LAG1, LAN6 for LAG2,…)
1. Link aggregation on or off
2. LAG Mode 0 = Round-robin
- fault tolerance and load balancing
1 = Active-backup, only one slave in the bond is active
- fault tolerance
2 = Balance-XOR
- fault tolerance and load balancing
3 = Broadcast, transmit everything on all slave interfaces
- fault tolerance
4 = 802.3ad Dynamic link aggregation
- fault tolerance and load balance
- requires switch that supports IEEE 802.3ad
5 = Adaptive transmit load balancing
- fault tolerance and load balance
- requires no special switch support
6 = Adaptive load balancing, includes Adaptive transmit load
- fault tolerance and load balance
- balancing plus receive load balancing, requires no special
switch support
3. Rate 0 = slow, Request link partner to transmit LACPDU every
30 seconds
1 = fast, Request link partner to transmit LACPDU every
1 second
4. Setting the MII link monitoring frequency (how often the link state of each slave is
inspected for link failure) 0 = off, 1..255ms