Fig
.
F
INSTALLATION
Before installation, you must make sure that the system is not connected to the mains! It is mounted on outer wall.
In rooms at higher level or in case of no
balcony, the system is appropriate to be installed at the lower left or right corner below the window.
This facilitates installation and replacement of the filter.
Sequence of installation:
1.
Drill a circular hole in the wall. Opening
is suitably to be drilled with an electric diamond drilling machine with a standard Ø110 mm.
2.
The external part of the system / outer grid with adjoining thereto outer housing / are fixed to the outer opening of the wall by the 4 fixing screws Fig. 2.
3.
The inner grid is removed by pulling (fig.3).
4.
Take the fixing base and position it in front of the wall opening using the 4 universal dowels 5x20 (for this mounting use the holes provided Fig.3b).
5.
Place the system into the opening of the fixing base (Fig. 3c), and then connect to the power supply (Fig.3g) COMPULSORLY following the scheme
for "Electrical Connection" (Fig. 5).
6.
Attach the system to the fixing base with the help of 4 screws 3x13 (use provided mounting holes Fig.3d).
7.
Put the
front grid (Fig. 3a).
REMARK
System power cable must be long enough to allow removal of the inner part of the system when changing filters and installing Fig. 3f.
IMPORTANT
•
Switch off mains supply before making any electrical connections or maintenance.
If in any doubt contact a qualified electrician.
•
The appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities without
being given supervision.
•
Precautious must be taken to avoid back-flow of gases into the room from the open flue or other open-fire appliances
.
Fig. 3b
Mounting hole
Fig. 3a
Fig.3d
Terminal
~
230
V
/50
Hz
Fig.3e
Mounting hole
Wall mounting
Power Cable
Fig. 3f
Fig. 2
Setscrews
Inside
Fig. 3c
Mounting hole
Outside
