Key Features
•
Safe handling with slip-proof rubberised housing
•
Signals if press not completed correctly - Immediately
after the pressing cycle a green lights shows if the required
pressing force was achieved, a red light if not
•
Automatic press cycle. Once it starts, it will automatically
complete. (manual override)
•
Electronic log book allows for quick and precise
analysis of errors for servicing and repair
•
Electronic monitoring of the jaw locking
bolt and visual error indicator (KPL)
•
When you reach the maximum number of presses
before a service is required a warning light flashes.
The machine will not close down enabling you to
complete the job in hand.
•
Redundant switch-off
•
Rotatable head (KPSA)
Tool Operation
Holding the tool securely, press and hold the start button for
2 seconds to begin the automatic press cycle (the green LED
will go out). Release the start button and continue to hold the
tool securely. The green LED will light when the press cycle is
complete. To cancel the automatic press cycle press and hold
the release button on the side of the tool until the tool turns off.
If the red LED lights up, press the start button. If the tool does
not run, call Kembla Hong Kong for advice. If the red and
green LEDs flash alternately, the tool is ready for a service,
contact Kembla Hong Kong Customer Service Centre.
The tool will turn off automatically after 30 minutes of no use.
Turn the tool ON by quickly pressing and releasing the start
button and open the jaws around the fitting.
Tool Maintenance
Carry out basic inspection of the pressing device and jaws prior
to each use to ensure they are clean and free from debris and
dirt. The pressing jaws should be visually inspected to ensure
there are no cracks. If there are any cracks in the pressing jaws,
do not use them, as there is risk of the jaws shattering and
potential injury from flying fragments. It is recommended to
always wear appropriate eye protection whenever using the
pressing device. When inspecting the pressing jaws, also ensure
that there are no foreign material deposits and that the contours
of the jaw surfaces are in order. Failure to do this may result in
damage to the jaws and/or the pressing device. Always remove the
battery before performing regular cleaning and maintenance work.
The pressing device, jaws and batteries must be serviced at
least within 40,000 presses. Failure to have the required services
carried out may affect the warranty.
Tool Service Program
The Kembla Hong Kong tool service and repair program
is easy, ensures minimal down time and provides known
maximum costs for repairs. The key components of the
program include:
•
Replacement tools available while your tool is being
serviced/repaired
•
Maximum repair price guarantee: the cost won’t exceed
our maximum repair price and if the cost of repair is less,
you only get charged that amount
•
No fix, no charge
•
Up to 12 months warranty on repairs
Any service or repair of the KemPress
®
pressing tool or jaws,
requiring opening the device, or mechanical repairs, shall only
be carried out by MM Kembla or their authorised agent.
Failure to do so may void the warranty.
11
®