WARNING
This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
This product is not suitable for direct installation in the ground, nor in a retaining wall where the ground may
become saturated behind.
This product is not suitable for installation in or near a coastal or marine environment.
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
NH016W / NH017W
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse, or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class II double insulated
•
This product series is IP44 rated
INSTALLATION
Note - If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods)
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas/water pipes or electrical cables
Fig. 1
•
Insert the sleeve into the cut-out and ensure that the mains cable is pulled through into the sleeve
•
Fix the sleeve to the surface using suitable screws (not provided)
•
Remove the terminal cover of the luminaire by unscrewing the three screws
•
Feed the mains cable through the gland on the rear of the terminal cover
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),
N - Neutral (blue)
•
Replace the terminal cover
•
Tighten the compression gland ensuring a tight seal is made
•
Insert the body of the luminaire into the sleeve ensuring that the side blades locate into the slotted
holes in the side of the sleeve
•
Switch on and check for correct operation
WARNING
This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
This product is not suitable for direct installation in the ground, nor in a retaining wall where the ground may
become saturated behind.
This product is not suitable for installation in or near a coastal or marine environment.
Fig. 1
• Insert the sleeve into the cut-out and ensure that the mains cable is pulled through into the sleeve
• Fix the sleeve to the surface using suitable screws (not provided)
• Remove the terminal cover of the luminaire by unscrewing the three screws
• Feed the mains cable through the gland on the rear of the terminal cover
• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),
N - Neutral (blue)
• Replace the terminal cover
• Tighten the compression gland ensuring a tight seal is made
• Insert the body of the luminaire into the sleeve ensuring that the side blades locate into the slotted holes in
the side of the sleeve
• Switch on and check for correct operation
