• Ensuring correct polarity is observed, carefully wire as shown in Fig. 2. Two cables can be
inserted into the push-fit terminal block in order to achieve loop-in / loop-out wiring
• Switch on and check for correct operation
Fig. 2
INSTRUCTIONS
–
BATSxx
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following products:
BATS2 / BATS4 / BATS5 / BATS5H / BATS6 / BATS6H
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire
is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class I and must be earthed
•
This product series is IP20 rated
INSTALLATION
Note - If this luminaire
is being used in conjunction with an external PIR or sensor, please confirm with
the manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods)
•
Squeeze the sides and hinge the diffuser away from the fitting (see Fig. 1)
Fig. 1
•
Mark the location of the fixing holes and drill the holes ensuring not to infringe with any gas/water
pipes or electrical cables. The fitting can also be mounted over conduit boxes: for distance between
fixing centres please see below:
Part Code
Distance (mm)
BATS2
415
BATS4
600
BATS5 / BATS5H
600
BATS6 / BATS6H
600
•
Ensuring correct polarity is observed, carefully wire as shown in Fig. 2. Two cables can be inserted
into the push-fit terminal block in order to achieve loop-in / loop-out wiring
Fig. 2
•
Switch on and check for correct operation
Squeeze
WARNING
GENERAL
This luminaire must be disconnected from the circuit if subjected to any high voltage or
insulation resistance testing. Irreparable damage will occur if this instruction is not followed.
This product contains a light source of energy efficiency class E (BATSx, BATSxH) /
D (BATSxUHL) to Regulation (EU) No. 2019/2015.
This product contains a non-replaceable LED light source and a control gear which can be
replaced by a professional.
