ML Accessories AXREMC, Инструкция по установке и обслуживанию

Страница: 4 / 6

BUTTON FUNCTION
Press the “ON/OFF” button, the light goes to constant on/off mode, sensor is
disabled. Press “Reset” or “Sensor motion” button to quit from this mode and the
sensor starts to work
Press “Reset” button, all parameters are same as setting of DIP switch or factory
settings.
Press “Sensor motion” button, the light quits from the constant on/off mode, and
the sensor starts to work (The latest setting stays in validity)
Press “DIM Test” button, the 1-10 V dimming works to test whether the 1-10Vdc
dimming ports are connected properly. After 2s, it returns to the latest setting
automatically.
Short press “DIM+ / DIM-“ button to transmit dimming signal. The brightness of
the lamp adjusts at 5% per unit.
(only apply for sensor with daylight harvesting function)
Long press>3s, sensor will take current light level as target lux level, to dim up/
down load automatically according to the change of ambient light level. (only
apply for sensor with daylight harvesting function)
Note: Detection area / Hold time / Stand-by period / Stand-by dim level /
Daylight sensor can be adjusted by pressing the corresponding button. The latest
setting will stay valid.
Press the “TEST 2S” button can enter the test mode anytime. At the mode, the
sensor parameters as below: Detection Area is 100%, Hold Time is 2s, Stand-by
Dim Level is 10%, Stand-by Period is 0s, daylight sensor disable. This function
only for testing. Quit the mode by pressing “RESET” or any other functions
buttons.
Scene
Options
Detection
Area
Hold time Stand-by
period
Stand-by
dim level
Daylight
Sensor
Induction
model
QS1 100% 30S 1min 10% 5Lux Hs
QS2 100% 1min 3min 10% 10Lux Hs
QS3 100% 5min 10min 10% 30Lux Hs