MKS 260 PS-7, Инструкция по эксплуатации

Страница: 45 / 53

Chapter Four: Operation General Information
35
Chapter Four: Operation
General Information
1. Ensure that the 260 PS-7 unit is properly installed.
Refer to Mounting Instructions, page 25, for more information.
2. Verify that the Line Voltage Selector on the rear panel of the unit is set to the proper
voltage.
Refer to How To Set the Line Voltage, page 27, for more information.
Caution
The Line Voltage Selector on the 260 PS-7 unit must be set to the
proper input voltage before you connect the power cord and turn on
the power. Otherwise, the unit will be severely damaged.
3. Ensure that the Power On/Off Switch is OFF.
Caution
Plugging the cables in with the power supply ON can damage the 260
PS-7 unit or can cause the unit to malfunction.
4. Connect the 1153 MFC and the Type 243 controller to the connectors on the rear panel
of the 260 PS-7 unit (refer to Figure 7, page 32) using the proper interface cables.
The interface cables are listed in Table 5, page 20.
Caution
Ensure that the cables are plugged STRAIGHT into the Type “D”
connectors on the 260 PS-7 unit. Plugging the cables in improperly
(such as on an angle) can damage the 260 PS-7 unit or can cause the
unit to malfunction.
5. Connect the AC Line Cord into the AC Line Cord Connector on the rear panel of the unit
(refer to Figure 7, page 32).
6. Plug the AC Line Cord into the power line and turn on the Power On/Off Switch.
For protective earthing, plug the power cord into a properly grounded outlet.