Technical Documentation
KFG-P 2000
mk North America, Inc.
|
105 Highland Park Drive
|
Bloomfi eld, CT 06002
|
(860) 769-5500
|
www.mknorthamerica.com
©2022
|
Page 24
mk North America, Inc.
|
105 Highland Park Drive
|
Bloomfi eld, CT 06002
|
(860) 769-5500
|
www.mknorthamerica.com
©2022
|
Page 25
9
CONVEYOR MAINTENANCE - TENSIONING & GREASING OF DRIVE CHAIN (CONT.)
9.2
Tensioning & Greasing of the Drive Chain - KFG-P 2000 AS
Loosen bolt (1) at the upper and lower surface and remove
the protective cover.
Loosen fastening screws (1) of the gearmotor (2). Tighten
the drive chain (3) by pushing the gearmotor downwards.
In this procedure, be careful not to tighten the drive chain
too much. The chain tension should be set between 2 and
6 mm.
Greasing the Drive Train
The drive chain (1) must be lubricated with grease in
accordance with the maintenance instructions (see
Section 6). During greasing, the grease must be applied to
the edge of the chain, for example, with a brush in order to
guarantee that it penetrates the rack joint.
9
CONVEYOR MAINTENANCE - TENSIONING & GREASING OF DRIVE CHAIN (CONT.)
9.3
Tensioning & Greasing of the Drive Chain - KFG-P 2000 AU
Loosen bolt (1) at the upper and lower surface and remove
protective cover.
Loosen fastening screws (1) of the gearmotor (2). Tighten
the drive chain by pushing the gearmotor downwards. In this
procedure, be careful not to tighten the drive chain too much.
The chain tension should be set between 2 and 6 mm.
Greasing the Drive Chain
The drive chain (1) must be lubricated with grease in
accordance with the maintenance instructions (see Section
6). During greasing, the grease must be applied to the edge of
the strap, for example, with a brush in order to guarantee that it
penetrates the chain pin.
