MK Martin METEOR 87, Руководство оператора

Страница: 12 / 38

12
75-108 Meteor Snowblower
Assembly Instructions
Parts for Assembly
• 2 pc Hood Bearing
• 4 pc 5/8” Wavewasher (thin)
• 2 pc 5/8x2 UNF bolts
• 2 pc 5/8”UNF Locknut
• 1 pc 2 Hole Chute Clamp
• 1 page Assembly Instructions
Upon Receiving the Meteor Snowblower
The blowers are shipped in a packaged state
These Snowblowers are shipped without a hood turner device
Carefully remove the chute and PTO shaft from the area of the snowblower auger and set
them aside. Locate the bag or package of small components.
Remove the ties that hold the Plastic Ring on the blower and place base of the chute on top of
the plastic ring. (Note: Plastic Ring can be lightly coated with grease at this time).
Take two 5/8 bolts and drop them through the holes in the chute clamp, turn the clamp upside
down while holding the bolts in the holes. Place a 5/8 Wavewasher on the bolt, then a 5/8
Bearing, fi nish with another 5/8 Wavewasher. Turn the clamp rightside up with the washers and
bearings on the bolts. Carefully insert the bolts into the chute base and secure with the lock-
nuts.
Install the PTO with the shearbolt yoke at the gearbox. This will provide you with more space
when changing shearbolts.
Chute
Bolt
Clamp
Wave washer
Bearing
Plastic Ring