MK-370
Revision 06/05, Effective Date June 17, 2005
Page 20
SETUP, ADJUSTMENT and OPERATION
3. 45º Miter Cutting:
NOTE: To cut 45º Miters, the 45º Bullnose Miter Guide (MK Diamond Part No. 134585-MK) should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
(B)
Place the 45º Bullnose Miter
Guide on the Ruler/Stop
(C)
Position the 45º Bullnose Miter
Guide and tighten the retaining
thumbscrew
(D)
Position the tile on the 45º
Bullnose Miter with the Glazed
Side down
(G)
Perform the cut
Align Guide
to Ruler/Stop
Turn counter-
clockwise to loosen
Ruler/Stop
Turn clockwise
to tighten
Bull Nose
Miter
Hold Work
in Position
Direction
of Cut
(A)
Remove the Adjustable Cutting
Guide
Ruler/Stop
Turn counter-
clockwise to loosen
Adjustable
Cutting Guide
(E)
Turn the motor ON
On
Position
ON/OFF
Switch
Cooling Flow
Points
(F)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow)
(H)
Turn the motor OFF when work
is complete
Off
Position
ON/OFF
Switch
