MJX T20 Shuttle, Инструкция по эксплуатации, Страница: 6 / 8

A12
Power
ON OFF
OPEN
Trimmer Functions
Circuit Protection Devices
Repair and Maintainance
It's designed to adjust the helicopter flight alignment.
1. The power light indicator of the helicopter will start to blink fast when the battery voltage of
the helicopter drops to certain level. The helicopter will be out of control. Recharge is
necessary to resume the function.
2. To protect the helicopter and prevent any risks caused by the stuck of the main rotor. The
main rotor will stop rotating and the power indicator light of the helicopter will keep blinking
fast when the main rotor is stuck or being blocked for 3 seconds. Pull the throttle joystick to the
lowest position to re-launch the helicopter.
1. Use wet cloth to clean this product.
2. Avoid this product to be exposed in the sunlight or the heated place.
3. Do not soak this toy in the water, otherwise the electronic part will be damaged.
4. Switch off the transmitter and power of the helicopter when it is not used.
5. Batteries should be taken out of the transmitter when it is not used for a long time.
6. You are highly suggested to use all-new alkaline battery to make sure the helicopter can
develop its best flying performance.
7. Periodically check the plug and other parts, If any damage is discovered, please do not use
it until it is completely repaired.
4
When the helicopter is
flying,push down the
right control stick, the
helicopter nose will
incline upward and flies
reversely.
Backward
When flying the helicopter, if it keeps
spinning counterclockwise, press the
right gyro trim until it stops spinning.
When flying the helicopter, if it keeps
spinning clockwise, press the left
gyro trim until it stops spinning.
Press the right gyro trim
Press the left gyro trim
A12
Power
ON OFF
OPEN
A12
Power
ON OFF
OPEN