MJX T20 Shuttle, Инструкция по эксплуатации, Страница: 4 / 8

Charging the Helicopter
Flight Environment
Preparation for Flight
B. Connect the USB charger to the computer to charge the helicopter
Connect the USB charger to the USB interface of the computer,
Ensure that the helicoper is in a “OFF” power status, then, plug the
output jack of the USB cable into the charging socket of the
helicopter.(pic 6)
1. Indoor , stay away from unstable airflow generated by air conditioners or fans and without
table lamps or other dangerous objects.
2. Wide open space : Recommended minimum 3M ( wide ) x 5M ( length ) x 2.5M ( height )
3. Since this product is using of the infrared remote control technology, operating under
strong sun light or other any other light may cause lost of control.
Must set the remote control at the “OFF” position before operating.
1. Turn on the helicopter and the searchlight will keep flashing rapidly.After a few seconds, the
searchlight will turn to slowly blinking,indicating that the helicopter is ready to connect with
the remote control.
2. Firstly, select the "A","1" or "2" channel;turn on the remote control and the power light of the
remote control will blink slowly; push the throttle control stick up to the top, then push it to the
bottom, the power light of the remote control will keep rapidly blinking, meaning that the
remote control is sending out connectional signal.Once signal connection is done, the power
light of the remote control will turn to constant "ON" without blinking.
3. Slowly push up the throttle stick and the helicopter takes off.
2
(1) There are two ways available to charge the helicopter.
A. Use the remote control to charge to helicoper
Open the charger compartment on the remote control by sliding
down the cover.
Ensure the helicopter is in a “OFF” power status.
Connect the USB charger to the USB interface of the remote
control. Plug the output jack of the USB cable into the charging
socket of the helicopter. Then, charging is beginning.(pic 5)
(2) The light of the remote control/USB charger is off when charging
is proceeding and will turn on automatically when charging is
done. Fully charge takes approximately 40 minutes.
Hints
Select channel 1 and channel 2 and operate maximum 2 helicopters simultaneously.
Not to use the same channel by 2 helicopters at the same time.
Set the connection one by one. Otherwise, it may not be connected.
Once turn off the power. The connection procedure must be repeated to operate the
helicopter.
It is advised to select channel A if there's only 1 helicopter is playing.
Pic. 6
Pic. 5