MJX F47, Инструкция по эксплуатации

Страница: 7 / 11

6
Turn on the remote control. To activate the remote controller,slowly
push up the throttle stick to the top and then push it down to the bottom.
The remote controller is activated once you hear a beep sound.Then, the
indicator light flashes rapidly while the remote controller is sending out
connectional signal.
Connect the battery plug to the helicopter battery cable,the indicator
light of the helicopter will keep slowing flashing,set the helicopter down
to a platform. Once the helicoter receives the connecting signal,the
indicator light of the helicopter will keep flashing rapidly to check the
Preparation for flight
gyro,then,push up the throttle stick slowly to takes off the helicopter.
If the helicopter is flying slightly to one side, please use the trimmer
button to tune it to balance.
Check and regulate the swashplate of the helicopter
(1) If the swashplate is slightly inclined, it is okay to regulate the trimmer
button of the remote control to get the swashplate retain horizontal.
(2) If the swashplate is greatly inclined, then, it should be better to
regulate the length of the servo connecting bar to get the swashplate
parallel to the ground. The operation instruction are specific as follow:
The swashplate of the helicopter should be kept horizontal, otherwise, the
helicopter will fly forward/backward/leftward/rightward automatically even
though no control signal is given. Hence, it is very important to check and
confirm that the swashplate is horizontal before flying the helicopter. To
get the swashplate horizontal, there are two ways available for regulation.