AFTER RETURNING TO SLIP
STEP 7 Shut Down Engines
Depress START/STOP switches. Later, after the cooling fans have had a chance to
work a bit, Depress top IGNITION switches so light disappears. TURN OFF ENGINE
BATTERY p4 rocker switches below.
STEP 8 Connect 50 AMP Shorepower
On earlier boats, betore the dual direction Glenndinning was installed, It’s necessary to
pull the 50 AMP cord out of the transom, using a fender whip through the strap eye if an
assist is necessary. After plugging in, turn on 50 AMP power at Dock.
Turn OFF toggle Switch on the INVERTER Panel p6 and INVERTER p1. Turn ON
SHOREPOWER 1 p3 and SHORE 1/110v GEN. Check to see that Voltage is present on
both 240v and 120v panels.
Be sure that HOUSE BATTERY CHARGER and START BATTERY CHARGER
breakers p4 are ON and check to see that the 12 volt meter p7 is rising or over 13 volts.
STEP 9 Shut Down Systems.
Probably the easiest procedure, rather than having to turn off many individual 12v
breakers is to simply turn OFF HOUSE BATTERY Rocker Switch p8. Then to get back
in business, there is only one switch to turn back on.
On the 240v Panel, leave ON REFRIGERATOR p2 and BAR p1 if wanting to keep
contents cold.
STEP 10 Leaving the Boat
If leaving the boat for an extended period of time and not plugged into shorepower, such
as on a mooring or in storage (a week or more), turn OFF the switch on top of the
Inverter in the starboard settee locker
…
otherwise the Inverter will continue to slowly pull
down the battery charge and kill the batteries.
Leave the 3 BILGE PUMP Switches at the helm on AUTO.
Содержание 50z Downeast
