CHAPTER 4
STEERING CONTROL SYSTEM
NAV LTS
FWD
Underway
AFT
At Anchor
WIPER
WASHERS
Read Instr
Booklet.
Press to
Sound
HORN
Press when
Raising Rode,
Chain & Anchor
to Wash with
Fresh Water
With the exception of the Anchor Washdown which is activated along with the “Windlass” breaker
(and must have the “Water Pressure” switch ON as does the washer function of the “Wiper”
switch) funcitons of this panel on the console are activated by turning on their respective breaker
switches on the DC Electrical Panel in the main saloon.
Functions of the panel rocker switches are described below the corresponding switch:
4.4
POWER TRIM CONTROL PANEL
Activate by turning on the ignition. The current position (angle) of the drivea can be shown on the
EVC Display.
To move both drives simultaneously, RAISE the Bow (and to lift the drive up) PRESS the central
“Up Arrow”. To LOWER the Bow ( and lower the drive) PRESS the central “Down Arrow”.
To move just one drive at a time, such as raising one drive up to reduce drag while operating just
a single drive, use the small black buttons on either side, instead of the central arrows.
Emergency Trimming
. If a fault prevents the trim panel from working, PRESS & HOLD the
BACK button (--) on the EVC Control Panel then trim the drive using the Trim Panel. This action
over-rides preset automatic trim limits.
4.5
FOUR TRIM MODES
