BEAM SPOT WASH (3IN1) 380W
BEAM SPOT WASH (3IN1) 380W
DMX Terminator:
In the Controller mode, at the last fixture in the chain, the DMX output has to be
connected with a DMX terminator. This prevents electrical noise from disturbing and
corrupting the DMX control signals.
The DMX terminator is simply an XLR connector with a 120Ω (ohm) resistor
connected across pins 2 and 3, which is then plugged into the output socket on the
last projector in the chain. The connections are illustrated below.
Function Set
4
Light panel schematic diagram is shown in Picture. Above title display light name.
Below is the status bar,show current light signal, lamp status, fault(When there is a
fault message not viewed, display“ERR”
，
no is display “NOR”). etc.
This light supports the DMX/RDM protocol. When the light is searched by the RDM
host, the panel will display the three letters "RDM". ------------
Display and operation are similar to "Android operating system", use your fingertips
or blunt hard objects to click on the corresponding item to operate.
Note:
Do not use sharp or sharp objects to click on the display to prevent damage.
Operation Menu
1. Operate the light with an intuitive touch or an auxiliary input
(touch-enabled product)
The left area is the TFT display area and the touch area
，
click on the panel
content with your finger or blunt hardware, then you can complete the
parameter setting or view status.
The right area is the auxiliary input, if you do not use the touch function that
comes with the TFT, you can use the auxiliary input to select the item you
want to set or view to complete the operation.
2. Parameter value input
When the selected parameter item needs to input a value, the window shown in
picture will open as below:
Set the value:
You can pull the slider directly to quickly set the desired
value, you can also click the “Up” or “Down” button on the right to set the
desired value precisely or use the auxiliary input to set it.
Application value:
When setting the data with the "Up" or "Down" buttons,
the value is sent to the fixture immediately, but the value is not saved.
Save the value:
at any time, click the "OK" button in the lower right
corner,then save the current value to the internal storage. The next time
you turn it on, the saved value is applied to the fixture.
5
