MiX Telematics FM 3617i, Руководство по установке, Страница: 22 / 39

22 | P a g e
6.1 Code Plug Socket Installation
Please follow the instructions, regarding the positioning of product
components, as contained in the “Safety”
section of this document.

The Code Plug Socket must be installed inside the passenger
compartment or the driver cabin, to protect it from possible damage by
water or other environmental factors.

The Code Plug Socket should not be installed in or near the ventilation
or heating systems, which may cause damage to it due to overheating.

The Code Plug Socket should be installed in a position where it will not
be subjected to pressure, impact or excessive vibration.

Select the installation position carefully before proceeding with the
installation.

Mark and drill or cut the required hole.
Hole size = 13/16” or 20 mm

Remove the mounting clip from the socket.

Remove the protection film from the adhesive surface of the foam ring and press it firmly against
the back of the interface.

Insert the socket into the mounting hole and slide the mounting clip into position.
6.2 Positioning the FM 3617i/FM 3717i/FM 3817i Unit
Please follow the instructions, regardi
ng the positioning of product components, as contained in the “Safety”
section, of this document.

The FM 3617i/FM 3717i/FM 3817i must be installed inside the passenger compartment or the
driver cabin, to protect it from possible damage by water, solvents, fuel or other environmental
factors.

The FM 3617i/FM 3717i/FM 3817i should not be installed in or near the ventilation, heating
system, or hot surfaces which may cause it to overheat or be damaged by condensed water
vapour.

The FM 3617i/FM 3717i/FM 3817i should be installed in a position where it will not be subjected
to pressure, impact or excessive vibration. Uneven surfaces, where the box can be deformed or
damaged should be avoided.

Select the installation position carefully before proceeding with the installation.

Mark and drill the required holes.

Route cables from the unit to the appropriate senders within the vehicle. Additional information
can be found in the “Harness Installation” section of this document.
After connecting the system components and performing a system test, mount the vehicle unit securely,
making use of the optional metal armored housing, if required. The armored housing is available as a spare
part and is used to protect against tampering.