- 10 -
If you want to reduce the running belt tension please rotate the wrench counterclockwise, attention to the
left and right to rotate the same distance.
Adjusting the belt in the middle
When you use a running machine, because running feet of power is not as big as the pressure imbalance
on the running belt, resulting in running off center. This deviation is normal, when no one is in operation
on the running belt while running, it will come back to the Center. If not back to the Center, you will need
to run back to the Center
。
1.
No-load running the treadmill, speed 6km/H
。
2.
2. observe the running distance to the left and right side
If the left, using the hex wrench, turn the left screw 1/4 clockwise circle
If the right, using a hex wrench, turn the right screw clockwise 1/4
If the running belt is still not in the Middle, and repeat the action until adjusted to an
intermediate
3.
After adjusting running belt to the Middle, set the speed to 16km/H, and watch the running belt
deviation and running smooth, if biased, repeat adjustment steps
。
4. WARING
！
Do not tighten the drum excessive
！
This will lead to permanent damage of bearing
！
If the above steps do not work, you will need to run and then tighten
。
T:tight
L:Loosen
Lubricant
Treadmill factory-over when the lubricating oil. But check the lubrication of running, which helps keep the
treadmill in the best State. Treadmill in use years or after 100 hours of operation, you must add lubricant.
Every 30 hours of use or after 30 days, from within the side-wing with the start reached encouraged to
touch the running surface, touch silicone oil, you do not need to add oil if you touch the surface when
there is a strong sense of dry, please follow the instructions for lubricating operations.
Use of non-petroleum silicone oil
T
L
L
T
