- 9 -
E02
Explosion-proof protection
1
．
Change motor or wires
。
2
．
Change the IC board
。
E05
Over current protection
1
．
Overload
2
．
Need to add Lubricant
3
．
Change the motor
E06
Controller post error
Change the controller
E07
Lost the date
Change IC board or reset the date
E08
Safety key
Reset the safety key
11
、
Daily maintenance
Motorized treadmill maintenance
：
Proper maintenance is the key to your treadmill is always at its best, faulty maintenance can damage or
shorten the life of treadmill.
NOTICE:
-Do not use sandpaper or solvent to clean up the treadmill, treadmill controller portion is not directly
exposed to sunlight or moisture, so as not to damage
。
-Regular checking and locking all treadmill parts, damaged parts replaced immediately
。
Adjusting running belt
Adjust the running has two functions: the tension adjustment adjust and run with a central location.
Running at the factory is ready to adjust, but after using the running belt will stretch, friction will cause run
off center location with decorative strips and back cover damaged. In the running belt is stretched is
normal.
If you use a running machine, appears to run with a slipping or not smooth, you can adjust the tightness of
the running belt to improve
。
How to adjusting belt
6mm hex wrench inserted into the running belt adjusting screw on the left, 1/4 ring turn the wrench
clockwise to adjust the drum to tighten after walking belt
Repeat step 1, adjust the screw on the right side. Must determine the adjustment screws the same
distance, so that the rear drum will adjust relatively parallel to the frame
。
Repeat steps 1 and 2 until running belt does not slip
。
Note that the running belt not adjusted too tight. This bad run, additional pressure on the front/rear
drum, roller bearings and other damage, resulting in abnormal noise or other problems
。
