Mitutoyo EV Counter, Руководство пользователя

Страница: 20 / 76

2 - 4
No. 99MBC034B
2.3 Power On
When the power source is connected to the EV Counter, it en-
ters the counting stand-by state. To start operation and enter the
counting state, quit the stand-by state.
TIP The counting stand-by function is an alarm function that
is entered if there is a power interruption during use.
a) If a D-EV is not connected
(1) If the EV-16P or EV-16D is used,enter the RS-232C com-
mand or I/O signal (a HOLD signal to clear the error) in the
EV Counter. For information refer to chapter
5 RS-232C
COMMUNICATION FUNCTION ; and chapter 7 I/O
FUNCTION .
(2) If the EV-16Z is used, push in the spindles of all connected
gages to pass through the origins after completing the proce-
dure (1) described above.
b) If a D-EV is connected
(1) When the EV Counter and D-EV are on, the counting stand-
by state is entered.
[Display on the D-EV]
UNIT
+NG
GO
-NG
(2)-1
If the EV-16P or EV-16D is used, press the P.SET key to
quit the counting stand-by state and enter the counting state.
[Display on the D-EV]
UNIT
+NG
GO
-NG
(2)-2
If the EV-16Z is used, press the P.SET key to cancel the
counting stand-by mode, then the counter enters the origin
detection wait mode. All decimal points flash in the origin
detection wait mode.
[Display on the D-EV]
+NG
UNIT
GO
-NG