2-8
MAINTENANCE STANDARDS
3.
Sealants and Lubricants Table
ThreeBond 1207C/1212/1211; Silicon liquid gasket Oil resistant/Formed-in-place/Low viscosity
ThreeBond 13860D;
Anaerobic adhesive
4.
Regarding Submission of Parts for EPA Exhaust Gas Regulation
The following parts have been submitted in accordance with EPA emission regulation.
(1) Fuel injection assembly
(2) Fuel injection nozzle
(3) Turbocharger assembly
(4) Other related parts (including designated fuel and lubricant)
Apply to
Mating part
Sealant or Lubricant
How to Use
Oil pan
Crankcase
ThreeBond 1207C
Apply to seal.
Rear bearing cap seat on crankcase
Rear bearing cap
ThreeBond 1212
Apply to corners before
installing cap.
Side seals
Crankcase rear
ThreeBond 1211
Apply to side seals.
bearing cap
Cylinder head coolant hole plug
Cylinder head
ThreeBond 1386D
Apply to plug hole.
Crankcase coolant hole plug
Crankcase
ThreeBond 1386D
Apply to plug hole.
Crankcase oil hole plug
Crankcase
ThreeBond 1386D
Apply to plug hole.
Return oil hole blind plug or pipe
Crankcase
ThreeBond 1386D
Apply to blind plug or pipe.
of crankcase
Crankshaft threads
Crankshaft pulley
ThreeBond 1212
Apply to crankshaft thread
nut
before tightening nut.
CAUTION
When replacing parts, make sure to use OEM designated parts. If OEM parts are not used, the
exhaust emission’s warranty will be voided. New parts may be updated due to improvement. Fuel
and Exhaust system repairs should only be conducted by an authorized Mitsubishi forklift dealer.
Tampering or adjusting the fuel system components will void the warranty and could be in
violation of the EPA regulations. The fuel injection pump must be replaced as an assembly.