Mitsubishi S16R2-PTAW, Руководство по эксплуатации и техническому обслуживанию

Страница: 37 / 120

3-5
Chapter 3 OPERATION
Preparation for Cooling System
Coolant - Refill (Engine)
Note: If the specification of radiator differs from the
contents of this operation manual, follow the
manufacturer's operation manual.
1.
Make sure coolant drain cocks are closed securely.
2.
Remove the radiator cap, and add a mixture of wa-
ter and LLC of the specified concentration to the
specified level.
Note: (a) Determine the quantities of LLC based on the
coolant capacity and the LLC concentration
chart.
For the coolant, refer to
"COOLANT" (6-1) .
For the coolant capacity, refer to "MAIN
SPECIFICATIONS" (12-1) .
(b) For absolute air bleeding, loosen the air vent
plug.
3.
Check the radiator and other parts for coolant
leaks. Repair leakage if found.
4.
When coolant reaches the specified level, close the
radiator cap securely.
5.
With the manual stop lever placed in the pulled po-
sition, crank the engine for approx 10 seconds us-
ing the starter. Stop cranking for 1 minute, then,
repeat the cranking two or three times to bleed the
cooling system.
Note: Prepare for the lubricating system and refilling
the coolant to the Air Cooler.
6.
Check the coolant level in the radiator.
Fig. 3-8 Coolant Drain Cock (Engine)
Fig. 3-9 Coolant Drain Cock
(Engine water pump)
Fig. 3-10 Air Vent Plug (Engine Cooling System)
When adding coolant, use the same LLC concentra-
tion coolant that is currently in the cooling system.
Coolant
drain cocks
Left side Right side
The coolant drain cocks located in the crankcase
(behind the each fuel injection pump
accessory drive unit respectively).
Coolant
drain cock
Air vent plug