4
2
2.4. Selecting a fan speed
1
Press
button to select a desired fan speed.
• Each time you press the button, available options change with the display
A
on
the remote controller, as shown below.
Fan speed
Remote controller display
Low
High
2-stage
The display and the fan speed of the unit will differ in the following situations:
• When STAND BY and DEFROST are displayed.
• Just after the heating mode (while waiting to change to another mode).
• When the temperature of the room is higher than the temperature setting of the
unit operating in the heating mode.
• In the dry operation, the indoor fan automatically turns to low-speed operation.
Switching of fan speed is impossible.
2. Operation
TIMER SET
ON/OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
1
2.3. Selecting a temperature
TEMP.
s
s
s
s
s
To decrease the room temperature:
1
Press
button to set the desired temperature.
A
The selected temperature is displayed.
• Each time you press the button, the temperature value decreases by 1 °C.
s
s
s
s
s
To increase the room temperature:
1
Press
button to set the desired temperature.
A
The selected temperature is displayed.
• Each time you press the button, the temperature value increases by 1 °C.
• Available temperature ranges are as follows:
Cooling & Drying:
19 - 30 °C
Heating:
17 - 28 °C
Automatic:
19 - 28 °C
Circulation:
— (Not available)
• The display flashes either 8 °C - 39 °C to inform you if the room temperture is lower
or higher than the displayed temperature.
▼
▼
TIMER SET
ON/OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
1
↑
ON
OFF
ON
OFF
TIMER SET
ON/OFF
CLOCK
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
2
1
B
TIMER SET
ON/OFF
CLOCK
ON
OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
1
D
B
2
3
C
A
2.5. Using the timer
1)
Set the current time
1
Press
button to display the “CLOCK”
B
.
Remote
CLOCK
→
CLOCK
ON
→
CLOCK
OFF
→
No Display
controller display
A
2
Each time you press
button, the time increases in increments of one minute.
Each time you press
button, the time decreases in increments of one minute.
• Press and hold the button to rapidly change the time.
• The time changes in increments of one minute
→
ten minutes
→
in units of hour; in
this order.
• Approximately ten seconds after pressing the button, the display on the remote
controller will turn off.
The example shows a timer set for operation start at 8:00 and end at 17:00.
2)
Set the mode to continuous as follows
1
Press
button to display
D
.
3)
Set the time to start the unit as follows
2
Press
button to display
B
ON
.
3
Press
TIMER SET
button to set the time that you want the unit to start.
The start time is displayed at
A
.
4)
Set the time to stop the unit as follows
2
Press
button to display
C
OFF
.
3
Press
TIMER SET
button to set the time that you want the unit to stop.
The stop time is displayed at
A
.
5)
Set the mode to timer as follows
1
Press
button to display
D
.
