10
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
I FEEL COOL
DRY
AM
PM
CLOCK
˚C
AMPM
HEAT
RESET CLOCK
WHEN THE AIR CONDITIONER IS NOT GOING
TO BE USED FOR A LONG TIME
Clean the
filter before
installing.
TIMER OPERATION (ON/OFF TIMER)
It is convenient to set the timer when you go to
bed, when you get home, when you get up, etc.
How to set the ON timer
1
Press the
START
button during operation.
Each time the button is pressed, the ON timer mode
alternates between ON and OFF.
2
Set the time of the timer using the
HR.
and
MIN.
buttons.
Each time the
HR.
button is pressed, the set time in-
creases by 1 hour; each time the
MIN.
button is
pressed, the set time increases by 10 minutes.
To release the ON timer:
■
Press the
START
button.
How to set the OFF timer
1
Press the
STOP
button during operation.
Each time the button is pressed, the OFF timer mode
alternates between ON and OFF.
2
Set the time of the timer using the
HR.
and
MIN.
buttons.
Each time the
HR.
button is pressed, the set time in-
creases by 1 hour; each time the
MIN.
button is
pressed, the set time increases by 10 minutes.
To release the OFF timer:
■
Press the
STOP
button.
Programming timer operation
The ON timer and the OFF timer can be used in combination.
The timer of the set time that is reached first will operate first.
(“ ” mark indicates the order of timer operations.)
■
If the current time has not been set, the timer operation can-
not be used.
When it is not going to be used for a
long time:
1
Perform the FAN operation for 3 or 4 hours
to dry the inside of the air conditioner.
• To perform FAN operation, set the remote controller to
the highest temperature in the MANUAL COOL mode.
(Refer to page 8.)
2
Turn off the breaker.
CAUTION
Turn off the breaker when the air conditioner is not
going to be used for a long time.
Dirt may collect and this may cause a fire.
3
Remove the batteries from the remote con-
troller.
CAUTION
To prevent liquid leakage, take out all batteries when
the remote controller is not going to be used for a
long time.
When the air conditioner is to be
used again:
1
Clean the air filter and install it in the in-
door unit.
(Refer to page 11 for cleaning instructions.)
2
Check that the air inlet and outlet of the
indoor/outdoor units are not blocked.
3
Check that the ground is connected correctly.
CAUTION
Ground the unit.
Do not connect the ground to a gas pipe, water pipe,
lightning rod or the ground of a telephone. If the ground-
ing is incorrect, it may cause an electric shock.
TIMER
NOTE
If the main power is turned off or a power failure occurs
while AUTO START/STOP timer is active, the timer setting
is cancelled. As these models are equipped with an auto
restart function, the air conditioner should start operating
at the same time that power is restored.
Manual
“Cool
”
operation
