Mitsubishi Lancer Evolution IX 2006, Руководство по ремонту

Страница: 19 / 26

THERMOSTAT
ENGINE COOLING
14-19
REMOVAL SERVICE POINT
<<A>> RADIATOR UPPER HOSE DISCON-
NECTION
AC200641AB
Mating marks
Make mating marks on the radiator hose and the
hose clamp. Disconnect the radiator hose.
INSTALLATION SERVICE POINTS
>>A<< THERMOSTAT INSTALLATION
CAUTION
Make absolutely sure that no oil is adhering to
the rubber ring of the thermostat. In addition, be
careful not to fold over or scratch the rubber ring
when inserting. If the rubber ring is damaged,
replace the thermostat.
Install the thermostat being careful not to fold over or
scratch the rubber ring.
>>B<< RADIATOR UPPER HOSE
CONNECTION
AC200642
Mating marks
Projection
Water outlet fitting
AB
1. Insert each hose as far as the projection of the
water outlet fitting.
2. Align the mating marks on the radiator hose and
hose clamp, and then connect the radiator hose.
INSPECTION
M1141002500494
THERMOSTAT CHECK
ACX00400
1. Immerse the thermostat in water, and heat the
water while stirring. Check the thermostat valve
opening temperature.
Standard value:
Valve opening temperature: 80
±
1.5
°
C
ACX00401AB
Valve lift
2. Check that the amount of valve lift is at the
standard value when the water is at the
full-opening temperature.
NOTE: Measure the valve height when the ther-
mostat is fully closed, and use this measurement
to compare the valve height when the thermostat
is fully open.
Standard value:
Full-opening temperature: 93
°
C
Amount of valve lift: 9.5 mm or more
6. Harness bracket
7. Water outlet fitting
>>
A
<< 8. Thermostat
Removal steps (Continued)