Mitsubishi FR-BU2-1.5K, Инструкция по эксплуатации

Страница: 3 / 65

A-2
4. Additional Instructions
Also note the following points to prevent an
accidental failure, injury, electric shock, etc.
1) Transportation and mounting
(2) Trial run
3) Usage
(4) Emergency stop
(5) Maintenance, inspection and parts
replacement
(6) Disposal
(7) General instruction
CAUTION
•
Transport the product using the correct
method that corresponds to the weight.
Failure to observe this could lead to
injuries.
•
Do not stack the brake unit boxes higher
than the number recommended.
•
Install the product in a place which can
withstand its weight according to the
information in the instruction manual.
•
Do not install or operate the option unit if it
is damaged or has parts missing.
•
When carrying the brake unit, do not hold
it by the front cover. It may fall off or fail.
•
Do not stand or rest heavy objects on the
product.
•
Check that the mounting orientation is
correct.
•
Prevent screws, metal fragments or other
conductive bodies or oil or other
flammable substance from entering the
brake unit.
•
As this brake unit is a precision
instrument, do not drop or subject it to
impact.
•
Use the brake unit under the following
environmental conditions: Failure to fallow
may damage the product.
*1Temperature applicable for a short time,
e.g. in transit.
CAUTION
•
Before starting operation, confirm and
adjust the parameters. Setting parameter
different from the one set in the resistor
connected may not exhibit the best
performance or may cause resistor
overheat or alarm.
E
n
vir
o
nm
en
t
Ambient
temperature
-10°C to 50°C
(non-freezing)
Ambient
humidity
90% RH or less
(non-condensing)
Storage
temperature -20°C to 65°C *1
Atmosphere
Indoors (free from
corrosive gas, flammable
gas, oil mist, dust and
dirt)
Altitude/
vibration
Maximum 1000m above
sea level, 5.9m/s
2
or less
(conforms to JIS C
60068-2-6)
WARNING
•
Do not modify the equipment.
•
Do not perform parts removal which is not
instructed in this manual. Doing so may
lead to fault or damage of the product.
CAUTION
•
Provide a safety backup such as an
emergency brake which will prevent the
machine and equipment from hazardous
conditions if the inverter and brake unit
fail.
WARNING
•
Do not test the brake unit with a megger
(measure insulation resistance).
CAUTION
•
Treat as industrial waste.
Many of the diagrams and drawings in this
Instruction Manual show the products
without a cover, or partially open. Never
operate the products in this manner.
Always replace the cover and follow this
Instruction Manual when operating the
products.