EN-34
1.
Repeat steps 1-2 above.
2.
Press to highlight
Volume
and press / to select a desired sound level.
Standby Audio Out
Selecting
On
enables the function. The projector can output an Audio input signal when it is in standby mode and
Audio input and Audio out jack is correctly connected to devices.
When the projector enters standby mode, the audio will be interrupted briefly. This is not a product malfunction.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do not affect
the projection settings, operation, or performance.
•
Menu display time
in the
SYSTEM SETUP: Advanced
>
Menu Settings
menu sets the length of time the
OSD will remain active after your last key press. The time length ranges from 5 to 30 seconds in 5-second
increments. Use
/
to select a suitable time frame.
•
Menu position
in the
SYSTEM SETUP: Advanced
>
Menu Settings
menu sets the OSD position in five
locations. Use
/
to select a preferred position.
•
Language
in the
SYSTEM SETUP: Basic
menu sets your familiar language for the OSD menus. Use
/
to
select your language.
•
Splash Screen
in the
SYSTEM SETUP: Basic
menu sets a preferred logo screen to be displayed during
projector start-up. Use
/
to select a screen.
Shutting down the projector
1.
Press
POWER
and a confirmation message displays prompting you.
If you don't respond in a few seconds, the message will disappear.
2.
Press
POWER
a second time. The
POWER indicator light
flashes
orange, the projection lamp shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the projector.
3.
Once the cooling process finishes, the
POWER indicator light
is a
steady orange and fans stop.
4.
Disconnect the power cord from the wall socket if the projector will not
be used in an extended period of time.
•
To protect the lamp, the projector will not respond to any commands during the
cooling process.
•
To shorten the cooling time, you can also activate the Quick Cooling function.
See
"Quick Cooling" on page 45
for details.
•
Do not unplug the power cord before the projector shutdown sequence is
complete or during the 90-second cooling down process.
•
If the projector is not properly shut down, to protect the lamp, when you attempt
to re-start the projector, the fans will run for a few minutes to cool down. Press
POWER again to start the projector after the fans stop and the POWER
indicator light turns orange.
Direct power off
1.
The AC power cord can be pulled out during the projector is on. To protect the lamp, wait about 10 minutes
before re-starting the projector. (When you attempt to re-start the projector, the fans may run for a few minutes
to cool down. In such cases, press
POWER
again to start the projector after the fans stop and the
POWER
indicator light
turns orange.
2.
To protect the lamp, do not shut down the projector while the
POWER indicator light
is blinking green after
the lamp lights up.
3.
Before shutting down the projector, be sure to close the menu screen. If you shut down the projector without
closing the menu, the setting data of the menu may not be saved.
4.
If you shut down the projector while controlling the projector using the network function, the application
software such as e-Control™ may fail. In this case, close the application software first. After the connection
between the projector and the computer re-establishes, initialize the software again.
I
I
I
I
I
I
I
I
