4
9
7
8
Dismantle the left trunk trim panel and remove.
Save the fasteners.
Remove lights from lamp assembly to leave wire
harness in place.
10
11
12
Using the trunk latch for center, measure and mark locations for the pasters. Center them vertically on the flat
facing area. Put the pasters on the rear bumper in the locations shown.
Note the locating point direction
and hole sizes. Remove the fascia, secure on a padded bench and drill holes in Steps 10—12.
#8. 24mm Paster
#8. 24mm Paster
#7. 26mm Paster
#7. 26mm Paster
35 cm
30 cm
30 cm
35 cm
Drill 3 mm locator holes
Drill 3 mm center pilot holes
Drill 24 mm and 26 mm holes.
Trunk latch