Mitsubishi MOTORS ASX Series, Руководство пользователя

Страница: 381 / 514

l Use engine oil conforming to the follow-
ing classification:
• ACEA classification:
“For service C1, C2, C3 or C4”
• JASO classification:
“For service DL-1”
If those classifications are not available,
contact a MITSUBISHI MOTORS Au-
thorized Service Point.
NOTE
l
Use of additives is not recommended since
they may reduce the effectiveness of addi-
tives already included in the engine oil. It
may result in failure of the mechanical as-
sembly.
Engine coolant
E01000503437
To check the coolant level
A transparent coolant reserve tank (A) is lo-
cated in the engine compartment.
The coolant level in this tank should be kept
between the “LOW” and “FULL” marks
when measured while the engine is cold.
Except for diesel-powered vehicles 1600 models
FULL
LOW
Diesel-powered vehicles 1600 models
FULL
LOW
To add coolant
The cooling system is a closed system and
normally the loss of coolant should be very
slight. A noticeable drop in the coolant level
could indicate leakage. If this occurs, we rec-
ommend you to have the system checked as
soon as possible.
If the level should drop below the “LOW”
level on the reserve tank, open the lid and
add coolant.
Also, if the reserve tank is completely empty,
remove the radiator cap (B) and add coolant
until the level reaches the filler neck.
WARNING
l Do not open the radiator cap (B) while the
engine is hot. The coolant system is under
pressure and any hot coolant escaping
could cause severe burns.
Anti-freeze
The engine coolant contains an ethylene gly-
col anti-corrosion agent. Some parts of the
engine are cast aluminium alloy, and periodic
changing of the engine coolant is necessary
to prevent corrosion of these parts.
Engine coolant
10-07
OGAE18E1
Maintenance
10