- 13 -
Using the Program Keys
These keys can be customized (arbitrary input functions) using the functions at the machine control box.
The LED to the upper left of this key can also be customized (arbitrary display function) using the functions at the
machine control box. The default settings for this key are as follows.
*Switch input functions:
: UP counter clear(CCU)
: Not used (NO)
: Not used (NO)
*Lamp output functions:
: Not used (NO)
Refer to the machine technical documentation for details on setting methods used for customization.
Settings Data Copy Function
(Functionality is expanded when connected to the XC-G control box. Refer to
the XC-G technical documentation for further details.)
The control panel can be used to read the machine control box settings data and write to another control box.
Reading Settings Data (Control Box
→
Control Panel)
(1) Turn ON the power while pressing the
key. The display will indicate
.
(2) Turn the
key ON to copy the settings data from the control box to the control panel.
(3) Copying is completed successfully if the normal display appears after several tens of seconds. If M5 (
)
displays, an error has occurred. Use the following procedure to perform the operation again.
1) Turn the power OFF.
→
2) Turn OFF the M5 display.
→
3) Inspect the connector connection.
→
4) Repeat the operation from step 1.
Writing Settings Data (Control Panel
→
Control Box)
(1) Turn ON the power while pressing the
key. The display will indicate
.
(2) Turn the
key ON to copy the settings data from the control panel to the control box.
(3) Copying is completed successfully if the normal display appears after several tens of seconds. If M5 (
)
displays, an error has occurred. Use the following procedure to perform the operation again.
1) Turn the power OFF.
→
2) Turn OFF the M5 display.
→
3) Check the control box voltage/model.
→
4) Inspect the connector connection.
→
5) Repeat the operation from step 1.
Notes:
1. The settings data cannot be written if the voltage and model (control box model name) do not match. (M5
(
) displays.)
2. Never disconnect the control panel while reading or writing settings data. Control box operation after
disconnection cannot be guaranteed.
5. ERROR DISPLAY
The following error codes display at the stitch number display area in the unlikely case that an error occurs at
the motor, control box or detector and so forth.
Turn OFF the power switch after checking the error code and
perform inspection according to Table 1. If the error persists, please contact your sales representative.
Table 1 : Error Codes and Inspection Details
Error Code
Inspection Details
/POWER.OF
Check whether the power supply voltage is low, or the power supply capacity is insufficient.
The same display appears when the power is turned OFF, however, this does not indicate a breakdown.
/ E1
Check whether the wiring to the motor has shorted, or the machine load torque is excessively large.
/ E3
Check that the motor and encoder connectors are properly connected.
Also check to ensure that the machine is not locked.
/ E9
Check to ensure that the wiring to all solenoids (thread trim, presser foot lift etc.) is correct.
Check to ensure that the coils for each solenoid have not shorted.
/ M5
This error occurred when copying from the control panel. Check that the control panel connector is
properly connected. Check to ensure that the control box voltage and model (control box model name)
match.
Refer to the technical information manual for XC-G or XC-K series for details of errors other than those above.
MITSUBISHI ELECTRIC CORPORATION
FACTORY AUTOMATION SYSTEM
TOKYO BLDG. 2-7-3,Marunouchi Chiyoda-ku Tokyo 100-8310,Japan
